Recently Updated Pages
RFI-5G Mission Analysis and Requirements
Project description This project is performed as part of the IEEE Geoscience and Remote Sensing/F...
Federated Deployment Control Protocol
State of the Art The Federation Deployment Control Protocol (FeDeCoP) aims to manage the formatio...
Opporunistic Service Availability Dissemination Protocol
State of the Art The Opporunistic Service Availability Dissemination Protocol (OSADP) generates r...
Introduction
The concept of FSS was introduced by Professor A. Golkar in [1]. FSS are spacecraft that engage ...
COMMS Antenna Refurbishment
Materials PocketQube body: Should already contain all the components of the spacecraft, inluding ...
Helicoils
Materials This are the necessary materials to install helicoils: Instructions The initial step i...
Operational Procedures
Operational procedures list This section provides a set of routine and recommended procedures to ...
RFI-Dedicated Thread
RFI Thread Introduction Like many other subsystems, the Payload is a self-contained sub-system an...
Data Acquisition
Parameters: struct rfi5gParameters{ char* name; uint32_t timestamp; uint32_t temperature; ...
Mission Timelines
Mission phases are divided into Prelaunch, LEOP, In-orbit Commissioning, Operations, and Post-mis...
Mission Phases
The mission is segmented into five distinct phases: 1) Prelaunch, 2) LEOP, 3) In-orbit Commission...
Killswitches
The satellite has 2 killswitches located on the bottom PCB. These are connected in series, allowi...
COMMS Antenna deployer
Introduction The antenna deployment mechanism will consist of two elements: a dyneema string atta...
EGSE - Design Specifications
Document scope This document specifies the electronic and mechanical aspects necessary to underst...
EGSE - Wiring and Setup
The main objective of this section is to document and explain how to proceed with the wiring of t...
Tests as Run
DOCUMENT SCOPE The aim of this document is to clearly explain the tests performed during the dele...
Subsystem Verification (SSV)
The SSV of the OBC consists of two main components: hardware and software. Hardware Validation Th...
Antenna Design
INTRODUCTION The goal of PoCat payload 3 is to identify Radio Frequency Interference (RFI) in the...
Software Design
Overview As introduced in the previous sections, the On-board Computer (OBC) is responsible for g...
Hardware Design
Design Choices Up next is provided a table including the most important information of the OBC. I...