ᴾᵒCat: RFI K-Band Payload
In this book information about ᴾᵒCat-3 P/L , a RFI Monitoring payload in the K-Band, is found including a subsystem description hardware and software designs as well subsystem verification.
RFI-5G Mission Analysis and Requirements
Project description This project is performed as part of the IEEE Geoscience and Remote Sensing/F...
RFI-5G Design
RFI-5G payload designs. Includes electrical, mechanical and software.
RFI-5G Payload block diagrams
FE Block Diagram Power Supply Block Diagram Signal Conditioning Block Diagram 4. General bl...
RFI-5G Payload design
IGARSS_2023_Kband_RFI_Paper.pdf Payload Structure The payload is structured as a vertical stack ...
Antenna Design
INTRODUCTION The goal of PoCat payload 3 is to identify Radio Frequency Interference (RFI) in the...
Data Acquisition
Parameters: struct rfi5gParameters{ char* name; uint32_t timestamp; uint32_t temperature; ...
RFI-Dedicated Thread
RFI Thread Introduction Like many other subsystems, the Payload is a self-contained sub-system an...
Test
RFI-5G FE-Bottom SSV
Test Description and Objectives The objective of this test is to validate the correct operations ...
RFI-5G FE-Top SSV
Document Scope The objective of this document is to detail the procedures, results and conclusion...
K-Band VCO Calibration Procedure
Objective Measure the frequency response of the VCO and characterize it. Steps to follow Turn ...
Front-end Gain calibration Procedure
Objective Measure the total system gain at the output of the RSSI and equalize it. Steps to follo...
K-band Noise floor characterization Procedure
Objective Measure the RSSI obtained though all the 1GHz band with only noise and characterize it....
K-band CW characterization Procedure
Objective Measure the RSSI obtained though all the 1GHz band when inputting a CW and characterize...
P/L3 Envelope Detection characterization Procedure
Objective Characterize the capacity of the RFI Monitoring system to detect signals by Envelope De...
P/L3 Statistical pulsed signal characterization Procedure
Objectives Characterize the capacity of the RFI Monitoring system to detect pulsed signals by sta...
Tests as Run
RFI-5G FE-Top SSV asRun 23/10/2023
Document Scope The objective of this document is to detail the procedures, results and conclusion...
RFI-5G FE-Top SSV as run 13/11/2023 (1)
Document Scope The objective of this document is to detail the procedures, results and conclusion...
RFI-5G FE-Top SSV as run 13/11/2023 (2)
Document Scope The objective of this document is to detail the procedures, results and conclusion...