# K-band CW characterization Procedure

<h1 id="bkmrk-objectives">Objective</h1>
<p id="bkmrk-measure-the-rssi-obt">Measure the RSSI obtained though all the 1GHz band when inputting a CW and characterize it.</p>
<h1 id="bkmrk-steps-to-follow">Steps to follow</h1>
<ul id="bkmrk-turn-on-equipment-sp">
<li>
<p>Turn on equipment</p>
<ul>
<li>Spectrum analizer</li>
<li>Signal generator</li>
<li>Power supply</li>
</ul>
</li>
<li>
<p>Configure to desired parameters</p>
<ul>
<li>Spectrum analizer
<ul>
<li>Set center frequency in the middle of RSSI input band (869MHz)</li>
<li>Set enough span to observe the RSSI input band (30MHz)</li>
<li>Set RBW and VBW to an adecuate level</li>
</ul>
</li>
<li>Power supply
<ul>
<li>Set Voltage to 3.3V</li>
<li>Set current limit to 0.3A</li>
</ul>
</li>
</ul>
</li>
<li>
<p>Set up nucleo board and PC</p>
<ul>
<li>Make sure the proper code is loaded into the nucleo board</li>
</ul>
</li>
<li>
<p>Make connections</p>
<ul>
<li>Connect the power supply to the payload:
<ul>
<li>Vcc to PoL (RED)</li>
<li>GND to GND (BLACK)</li>
</ul>
</li>
<li>Connect the DAC output to the DAC_In (GREEN)</li>
<li>Connect the ADC input to the ADC_Out</li>
<li>Connect the signal generator output to the IF input PIN (BLUE)</li>
<li>Connect the spectrum analizer to the switched measuring pin (PURPLE)</li>
</ul>
<p><a href="https://wiki.nanosatlab.space/uploads/images/gallery/2023-04/top-k-band-testing-connections.PNG" target="_blank" rel="noopener"><img src="https://wiki.nanosatlab.space/uploads/images/gallery/2023-04/scaled-1680-/top-k-band-testing-connections.PNG" alt="Top_K-Band_Testing_Connections.PNG"></a></p>
<ul>
<li>Connect PC to ground (plug in the charger).</li>
<li>Connect necleo board to computer by USB.</li>
</ul>
</li>
<li>
<p>Power on power supply.</p>
</li>
<li>
<p>Begin the measurements procedure</p>
<ul>
<li>Run the flashed program in Debug mode.</li>
<li>Measure the signal observed with the spectrum analyzer.</li>
<li>Disconnect the spectrum analizer connected to the switched measuring pin (PURPLE).</li>
<li>Once the program stops at the breakpoint, collect the calculated mean and plot it in a data processing software like Matlab.</li>
</ul>
</li>
<li>
<p>Analyze the collected data.</p>
</li>
</ul>