K-band CW characterization Procedure

Objective

Measure the RSSI obtained though all the 1GHz band when inputting a CW and characterize it.

Steps to follow

• Turn on equipment

  • Spectrum analizer
  • Signal generator
  • Power supply

• Configure to desired parameters

  • Spectrum analizer
    • Set center frequency in the middle of RSSI input band (869MHz)
    • Set enough span to observe the RSSI input band (30MHz)
    • Set RBW and VBW to an adecuate level
  • Power supply
    • Set Voltage to 3.3V
    • Set current limit to 0.3A

• Set up nucleo board and PC

  • Make sure the proper code is loaded into the nucleo board

• Make connections

  • Connect the power supply to the payload:
    • Vcc to PoL (RED)
    • GND to GND (BLACK)
  • Connect the DAC output to the DAC_In (GREEN)
  • Connect the ADC input to the ADC_Out
  • Connect the signal generator output to the IF input PIN (BLUE)
  • Connect the spectrum analizer to the switched measuring pin (PURPLE)

  

  • Connect PC to ground (plug in the charger).
  • Connect necleo board to computer by USB.

• Power on power supply.

• Begin the measurements procedure

  • Run the flashed program in Debug mode.
  • Measure the signal observed with the spectrum analyzer.
  • Disconnect the spectrum analizer connected to the switched measuring pin (PURPLE).
  • Once the program stops at the breakpoint, collect the calculated mean and plot it in a data processing software like Matlab.

• Analyze the collected data.